LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1959 (Glow Plug System - F250-F550 Super Duty 6.0L (99P F450/550)) >> Removal And Installation >> Glow Plug Sleeve >> Installation

Glow Plug Sleeve: Installation

WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Verify the glow plug bore is completely clean and dry.
  2. Apply Threadlock 262 sealant to the glow plug sleeve in 2 places.
    3. Fig 1: Applying Sealant To Glow Plug Sleeve
    GF0005992Courtesy of FORD MOTOR CO.
  3. Install the glow plug sleeve into the glow plug bore until it bottoms.
    4. Fig 2: Installing Glow Plug Sleeve Into Glow Plug Bore Until Bottoms
    GF0005993Courtesy of FORD MOTOR CO.
  4. Clean the glow plug sleeve after installation with a nylon brush and solvent. Make sure Threadlock 262 sealant is cleaned out before it hardens.
  5. Install the press-in-place gasket.
    • Install new dowels in the cylinder head and the press-in-place gasket.
    6. Fig 3: Locating Gasket
    G04519005Courtesy of FORD MOTOR CO.
  6. Position the rocker arm carrier on the cylinder head. Install the bolts.
    • Tighten to 62 Nm (46 lb-ft).
    7. Fig 4: Identifying Rocker Arm Carrier Bolts
    GF0005824Courtesy of FORD MOTOR CO.
  7. Install the lifting bracket on the cylinder head.
  8. Install the cylinder heads. For additional information, refer to ENGINE - 6.0L DIESEL article.
scientia non olet · About LEMON Manuals