Removal And Installation

WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

Move the front seat forward.
Remove the vehicle jack. For additional information, refer to the owner guide.
Remove the rear seat. For additional information, refer to SEATING article.
Pull the carpet or mat back to expose the rear body insulator bolt head.
Remove and discard the bolt.
- To install, tighten to 80 N.m (60 lb-ft).

Fig 1: Locating Bolt

Courtesy of FORD MOTOR CO.

Remove the insulator.

Fig 2: Locating Insulator

Courtesy of FORD MOTOR CO.

NOTE: Do not reuse body support mounting fasteners. New fasteners must be installed for each fastener that has been removed or loosened.

NOTE: No lubricants of any kind are to be used during body insulator installation.

To install, reverse the removal procedure.