LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1947 (Anti-Lock Brake System -- F250-F550 Super Duty) >> Diagnostic Tests >> Pinpoint Tests >> Pinpoint Test B: DTCs C1095 and C1096 >> Code Description

Code Description

WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

ABS Hydraulic Pump Motor Circuit Failure/Open

Fused battery voltage for the hydraulic control unit (HCU) pump motor is supplied to the ABS module by battery junction box (BJB) fuse 23 (60A) along circuit 532 (OG/YE). Ground for the HCU pump, coil and ABS module is provided along circuit 530 (LG/YE). The ABS module supplies the voltage and ground for the pump motor. The 2 components are hardwired together, there are no connectors or wiring harnesses between the 2 components.

The ABS module performs 2 different tests on the pump motor to determine the condition of the motor. The first test is done when the ignition key is turned to the ON position and is used to test for a pump motor that may be locking up. The ABS module commands the HCU pump motor on for 100 ms (±6 ms) and then commands the pump motor off, once the pump motor is commanded off, it will generate a small amount of voltage. Six milliseconds after commanding the pump off, the ABS module will read the voltage that is being generated by the pump motor. If the voltage indicates the motor is spinning at less than 500 rpm, the motor may be locking up. If a locked up pump motor is detected 4 times, DTC C1095 will be set.

The second test is used to check for an open circuit and a short to voltage. Two seconds after the most recent (successful) pump motor off command, the ABS module will read the voltage that is being generated by the pump motor. If the voltage generated remains greater than 0.75 volt for more than 50 ms (±6 ms) after the off command, then a short to voltage may exist. If there is no voltage generated by the pump motor, then an open circuit condition may exist. If one or both of the conditions exists, DTC C1096 will be set.

Possible Causes

scientia non olet · About LEMON Manuals