LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1936 (Instrument Panel And Console F250-F550)) >> Removal And Installation >> Instrument Cluster Finish Panel >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: Ignition switch must be in OFF position if disconnecting the passenger airbag deactivation (PAD) switch electrical connector. Otherwise, a diagnostic trouble code (DTC) will be set in the restraints control module (RCM) memory and must be erased before releasing the vehicle.
  1. Position the ignition switch in the OFF position.
  2. Remove the instrument panel cluster finish panel.
    • Disconnect the electrical connectors.
    Fig 1: Identifying Instrument Panel Cluster Finish Panel
    GF0005260Courtesy of FORD MOTOR CO.
  3. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals