LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1933 (Seat System -- F250-F550 Super Duty) >> Removal And Installation >> Seat Control Switch - With Seat Integrated Restraints (SIR) >> Removal

Seat Control Switch - With Seat Integrated Restraints (SIR): Removal

WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the affected seat. For additional information, refer to Seat - Front, With Seat Integrated Restraints (SIR)  in this article.
  2. Remove the seat adjuster control knobs, covers and the seat side trim panel screws.
    • Remove the seat recliner lever cover screw and cover.
    • Pull to remove the lumbar control knob.
    • Remove the 3 seat side trim panel attachment screws.
    Fig 1: Identifying Seat Adjuster Control Knobs, Covers And Seat Side Trim Panel Screws
    GF0004986Courtesy of FORD MOTOR CO.
  3. Remove the 2 screws securing the lumbar adjuster control to the seat track riser.
    • Push the lumbar adjuster control inward to provide clearance for trim panel removal.
    Fig 2: Locating Lumbar Adjuster Control Screws
    G03925442Courtesy of FORD MOTOR CO.
  4. Pull the rearward lower corner of the side shield to disengage the metal retaining clip.
    5. CAUTION: Bend the side shield slightly to make sure the shield is not scratched by the recliner lever.
  5. Remove the side trim cover.
  6. Disconnect the seat control switch electrical connector.
    Fig 3: Locating Seat Control Switch Electrical Connector
    G03925443Courtesy of FORD MOTOR CO.
  7. Remove the 2 screws on the seat control switch.
    Fig 4: Locating Screws On Seat Control Switch
    GF0004987Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals