LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1914 (Windows And Glass -- F250-F550 Super Duty) >> General Procedures >> Windshield Reseal

Windshield Reseal

WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
Material

Item Specification
DOW AUTOMOTIVE 2-HOUR CURE
 		  
Dow Urethane Adhesive Betaseal® Express
 		 -
SIKA 2-HOUR CURE
 		  
Sika Urethane Adhesive Sika Tack ASAP
 		 -
  1. Remove the cowl vent grille. For additional information, refer to FRONT END BODY PANELS article.
  2. Remove the interior mirror. For additional information, refer to REAR VIEW MIRRORS article.
  3. Remove the windshield side garnish mouldings. For additional information, refer to INTERIOR TRIM AND ORNAMENTATION article.
  4. Remove the overhead console. For additional information, refer to INSTRUMENT PANEL AND CONSOLE article.
  5. Remove the inside visors. For additional information, refer to INTERIOR TRIM AND ORNAMENTATION article.
  6. Partially lower the front portion of the headliner or, if equipped, the roof trim panel and block with a suitable material.
  7. Clean the edge formed by the existing urethane and the glass on the inside at the top and sides and outside on the bottom of the windshield with an alcohol-free cleaner.
  8. Cut the urethane applicator tip to specification.
    Fig 1: Identifying Urethane Applicator Tip Dimension
    GF0005166Courtesy of FORD MOTOR CO.
    9. NOTE: Use either a high-ratio electric or battery-operated caulk gun that will apply the urethane with less effort and a continuous bead.
  9. Apply a bead of Urethane Adhesive to the cleaned area.
    10. NOTE: Make sure that all gaps in the urethane adhesive are smoothed into one continuous bead.
  10. Backfill the urethane application and clean the excess.
    11. CAUTION: The urethane adhesive must cure for a minimum of one hour before testing for air or water leaks.
  11. After the urethane has cured, check the windshield seal for air or water leaks through the urethane adhesive bead and add urethane adhesive as necessary.
  12. Raise the headliner or, if equipped, the roof trim panel.
  13. Install the sun visors. For additional information, refer to INTERIOR TRIM AND ORNAMENTATION article.
  14. Install the overhead console. For additional information, refer to INSTRUMENT PANEL AND CONSOLE article.
  15. Install the windshield side garnish mouldings. For additional information, refer to INTERIOR TRIM AND ORNAMENTATION article.
  16. Install the interior mirror. For additional information, refer to REAR VIEW MIRRORS article.
  17. Install the cowl vent grille. For additional information, refer to FRONT END BODY PANELS article.
  18. Clean the exterior and interior of the windshield glass with an alcohol-free cleaner.
scientia non olet · About LEMON Manuals