LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1904 (Engine - 5.4L (3V) - F250 & F350) >> In-Vehicle Servicing >> Hydraulic Lash Adjuster >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2007 Ford Pickup and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the camshafts. For additional information, refer to Camshaft - LH  or Camshaft - RH  in this article.
  2. Remove the remaining roller followers from the cylinder head being serviced.
    3. CAUTION: If the components are to be reinstalled, they must be installed in the same positions. Mark the components for installation into their original locations. Failure to follow these instructions may result in engine damage.
  3. Remove the hydraulic lash adjusters that are being serviced.
  4. Inspect the hydraulic lash adjusters. For additional information, refer to ENGINE SYSTEM - GENERAL INFORMATION article.
    5. NOTE: Lubricate each of the hydraulic lash adjusters with clean engine oil prior to installation.
  5. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals