LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1903 (Electronic Engine Controls - Gasoline Engine -- F250-F550 Super Duty) >> Removal And Installation >> Mass Air Flow (MAF) Sensor - 5.4L >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES article.
  2. Disconnect the mass air flow (MAF) sensor electrical connector.
  3. Remove the 2 bolts and the MAF sensor.
    • To install, tighten to 3 N.m (27 lb-in).
  4. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals