LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1901 (Engine Cooling System - F250-F550) >> Removal And Installation >> Radiator - Gasoline Engines >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the cooling fan shroud. For additional information, refer to Cooling Fan - Blade, Clutch and Shroud, 5.4L, 6.8L  in this article.
  2. Disconnect the lower radiator coolant hose.
  3. Push the available special tool into the fitting to release the tube retaining clip and remove the transmission cooler tubes from the radiator.
    4. Fig 1: Removing Transmission Cooler Tubes
    GF0005884Courtesy of FORD MOTOR CO.
  4. Remove the 4 bolts and the 2 radiator support brackets.
    • To install, tighten to 10 N.m (89 lb-in).
  5. Remove the radiator and the radiator insulators.
  6. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals