Removal And Installation
WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
- Release the pressure in the cooling system by slowly turning the pressure relief cap one half turn counterclockwise. When the pressure is released, remove the pressure relief cap.
- Using hose clamp pliers, clamp the coolant return hose.
- Using a suitable suction device, siphon the coolant from the degas bottle.
- Disconnect the radiator overflow hose.
- Disconnect the coolant return hose.
- Remove the 2 bolts and the degas bottle.
- To install, tighten to 10 N.m (89 lb-in).
- Apply Threadlock 262 to the bolts threads prior to installation.
- To install, reverse the removal procedure.
- Fill the degas bottle. Refer to Cooling System Draining, Filling and Bleeding in this article for the recommended coolant mixture and fill level.
WARNING:
To avoid personal injury, do not unscrew the coolant pressure relief cap while the engine is operating or hot. The cooling system is under pressure; steam and hot liquid can come out forcefully when the cap is loosened slightly. Failure to follow these instructions may result in personal injury.