LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1883 (Front Disc Brake System - F250-F550 Super Duty) >> Removal And Installation >> Front Brake Caliper Anchor Plate >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the brake pads. For additional information, refer to Brake Pads  in this article.
  2. Remove and discard the 2 brake caliper anchor plate bolts.
    • To install (F-250, F-350), tighten to 225 Nm (166 lb-ft).
    • To install (F-450, F-550), tighten to 400 Nm (295 lb-ft).
  3. Inspect the brake caliper anchor plate assembly.
    • Check the guide pin boots for damage.
    • Check the guide pins for binding and damage.
    • If pins are worn or damaged, install new pins. Lubricate the pins with silicone grease.
  4. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals