LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1873 (Transfer Case - F-150 & Mark LT) >> In-Vehicle Servicing >> Transfer Case Shift Lever >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2007 Lincoln Mark LT and 2007 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. Pry upward on consolette to release it from the floor clips.
    Fig 1: Prying Upward On Consulate
    GF0004047Courtesy of FORD MOTOR CO.
  2. Remove the transfer case shift lever.
    • Remove the shift lever boot screws.
      • To install, tighten to 12 Nm (9 lb-ft).
    • Remove the shift lever cover.
    • Remove the bolt.
      • To install, tighten to 24 Nm (18 lb-ft).
    • Remove the shift lever.
      Fig 2: Removing Transfer Case Shift Lever
      GF0004048Courtesy of FORD MOTOR CO.
  3. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals