LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1872 (Automatic Transmission Cooling System - F150 & Mark LT) >> Removal And Installation >> Transmission Fluid Cooler Tubes >> Installation

Transmission Fluid Cooler Tubes: Installation

WARNING: This page is about a different car, the 2007 Lincoln Mark LT and 2007 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the fluid cooler tube(s).
    • Tighten to 27 Nm (20 lb-ft).
    2. Fig 1: Locating Fluid Cooler Tube(s)
    GF0003752Courtesy of FORD MOTOR CO.
  2. Connect the fluid cooler tubes to the bracket.
  3. Install the fluid cooler tubes to the retainer.
  4. Connect the fluid cooler tubes to the radiator and the auxiliary fluid cooler if equipped.
  5. Install the secondary latches onto the cooler tubes.
  6. Position the air deflector and install the fasteners.
    7. Fig 2: Locating Fasteners
    GF0003747Courtesy of FORD MOTOR CO.
  7. Position the skid plate and install the bolts (4WD vehicles).
    • Tighten to 15 Nm (11 lb-ft).
      • Fig 3: Locating Bolts And Skid Plate
      GF0003480Courtesy of FORD MOTOR CO.
  8. Fill the transmission with clean automatic transmission fluid specified for this transmission.
  9. Check for leaks.
scientia non olet · About LEMON Manuals