LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1851 (Safety Belt System - F-150 & Mark LT) >> Removal And Installation >> Safety Belt - Front, Center

Safety Belt - Front, Center

WARNING: This page is about a different car, the 2007 Lincoln Mark LT and 2007 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
WARNING: All safety belt assemblies (including retractors, belt tension sensor [BTS] if equipped, buckles, shoulder belt height adjusters [if equipped], child safety seat tether attachments and attaching hardware) should be inspected after every collision. All new belt assemblies should be installed unless a qualified technician finds the assemblies show no damage and operate correctly. Belt assemblies not in use during a collision should also be inspected and new assemblies installed if either damage or incorrect operation is noted. Failure to follow these instructions could increase the risk of injury in collisions.
NOTE: This procedure is for the SuperCrew and Crew Cab 20 percent seat with a lap belt.
  1. Remove the front 20 percent seat. For additional information, refer to SEATING article.
  2. Remove the RH upper seat side trim panel screw and trim panel.
  3. Remove the RH lower seat side trim panel screw and trim panel.
  4. Remove the safety belt anchor bolt and safety belt.
    • To install, tighten to 55 Nm (41 lb-ft).
    • The anti-rotation tab must be correctly aligned for correct installation.
  5. To install, reverse the removal procedure.
  6. Check the active restraint system for correct operation. For additional information, refer to Safety Belt System  in this article.
scientia non olet · About LEMON Manuals