Removal And Installation
WARNING: This page is about a different car, the 2007 Lincoln Mark LT and 2007 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
- Disconnect the license plate lamp electrical connectors.
- If equipped, disconnect the trailer harness electrical connectors.
- If equipped, detach the trailer harness pin-type retainer from the rear bumper.
- If equipped, disconnect the rear parking aid electrical connector.
- Remove the rear bumper nuts.
- To install, tighten to 175 Nm (129 lb-ft).
- Remove the rear bumper.
- To install, reverse the removal procedure.
- Transfer components as necessary. If equipped with a rear parking aid sensor, refer to PARKING AID article for additional information.
NOTE:
Anytime the rear bumper nuts are removed, discard and install new rear bumper nuts.