LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1849 (Bumper System - F150 & Mark LT) >> Removal And Installation >> Bumper - Front >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2007 Lincoln Mark LT and 2007 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the hood release retaining bolt.
  2. Position aside the hood release assembly.
    • Disconnect the hood release cable routing retainer.
    3. NOTE: The front bumper cover-to-front bumper bolts must be replaced with new bolts.
  3. Remove the 3 front bumper cover-to-front bumper bolts.
  4. Remove the hood-over slam bumper bolts.
  5. Remove the hood-over slam bumpers.
  6. Remove the 13 air dam retaining bolts.
  7. If equipped, disconnect the fog lamp electrical connectors.
  8. Remove the 4 bumper mounting bracket-to-front bumper nuts.
    • To install, tighten to 115 Nm (85 lb-ft).
  9. Remove the front bumper.
  10. To install, reverse the removal procedure.
    • Transfer components as necessary.
scientia non olet · About LEMON Manuals