LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1846 (Handles, Locks, Latches And Entry Systems) >> Diagnostic Tests >> Locks, Latches and Entry Systems >> Inspection and Verification

Inspection and Verification

WARNING: This page is about a different car, the 2007 Lincoln Mark LT and 2007 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. Verify the customer concern.
  2. Visually inspect the following for obvious signs of mechanical or electrical damage.
    VISUAL INSPECTION CHART

    Mechanical Electrical
    • Latches
    • Binding cables
    • Central junction box (CJB) fuse(s):
      • 18 (10A)
      • 107 (30A)
    • Circuitry
    • Door ajar switch(es)
    • Door lock control switch(es)
    • Door lock actuator(s)
    • Keyless entry keypad
    • Remote keyless entry (RKE) transmitter
    • Vehicle security module (VSM)
  3. If an obvious cause for an observed or reported concern is found, correct the cause (if possible) before proceeding to the next step.
    4. NOTE: Make sure to use the latest scan tool software release.
  4. If the cause is not visually evident, connect the scan tool to the data link connector (DLC).
    5. NOTE: The vehicle communication module (VCM) LED prove-out confirms power and ground from the DLC are provided to the VCM.
  5. If the scan tool does not communicate with the VCM:
    • Check the VCM connection to the vehicle.
    • Check the scan tool connection to the VCM.
  6. If the scan tool does not communicate with the vehicle:
    • Verify the ignition key is in the ON position.
    • Verify the scan tool operation with a known good vehicle.
  7. Carry out the network test:
    • If the network test passes, retrieve and record the continuous memory DTCs.
  8. Clear the continuous DTCs and carry out the self-test diagnostics for the VSM.
  9. If the DTCs retrieved are related to the concern, go to the Vehicle Security Module (VSM) Diagnostic Trouble Code (DTC) Index. For all other DTCs, refer to MULTIFUNCTION ELECTRONIC MODULES article.
  10. If no DTCs related to the concern are retrieved, go to Symptom Chart .
    VEHICLE SECURITY MODULE (VSM) DIAGNOSTIC TROUBLE CODE (DTC) INDEX

    DTC Description Action
    B1309 Power Door Lock Circuit Short to Ground Go to Pinpoint Test F .
    B1322 Driver Door Ajar Circuit Short to Ground Go to Pinpoint Test E .
    B1330 Passenger Door Ajar Circuit Short to Ground Go to Pinpoint Test E .
    B1338 Door Ajar RR Circuit Short to Ground Go to Pinpoint Test E .
    B1341 Power Door Unlock Circuit Short to Ground Go to Pinpoint Test F .
    B1574 Door Ajar LR Circuit Short to Ground Go to Pinpoint Test E .
    B1625 Lamp Keypad Output Short Circuit to Battery Go to Pinpoint Test I .
    B1626 Lamp Keypad Output Short Circuit to Ground Go to Pinpoint Test I .
    B2276 Less Than 2 Transmitters Programmed PROGRAM the remote transmitter. REFER to Remote Keyless Entry Transmitter Programming  in this article.
    B2425 Remote Keyless Entry Out of Synchronization Go to Pinpoint Test K .
    B2695 Keypad_A Switch Circuit Failure Go to Pinpoint Test G .
    B2696 Keypad_B Switch Circuit Failure Go to Pinpoint Test G .
    B2697 Keypad_C Switch Circuit Failure Go to Pinpoint Test G .
scientia non olet · About LEMON Manuals