LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1835 (Seat System - F-150 & Mark LT) >> Removal And Installation >> Seat - Front, 20 Percent >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2007 Lincoln Mark LT and 2007 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Due to locator pin location on the riser frame, 20 percent seats will not interchange between regular cab vehicles and SuperCab/SuperCrew vehicles.
  1. Remove the seat cushion.
    • While applying slight pressure, pull up at the front edge of the seat cushion, lift the cushion up and pull the cushion out.
  2. Disconnect the electrical disconnect (if equipped).
  3. Remove the 20 percent riser-to-floor front bolts.
    • To install, tighten to 48 Nm (35 lb-ft).
  4. Remove the 20 percent riser-to-floor rear bolts
    • To install, tighten to 48 Nm (35 lb-ft).
  5. To install, reverse the removal procedure.
    • Make sure the safety belts and buckles are accessible to the occupants after installation.
scientia non olet · About LEMON Manuals