LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1811 (Wheels & Tires -- F-150 & Mark LT) >> Disassembly And Assembly >> Wheel and Tire >> Assembly

Wheel and Tire: Assembly

WARNING: This page is about a different car, the 2007 Lincoln Mark LT and 2007 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Damage to the TPMS sensor may result if the tire mounting is not carried out as instructed.
    CAUTION: Use only a soap and water solution to lubricate the tire. Use of anything other than soap and water may result in damage to the TPMS sensor.
    NOTE: Do not mount the tire at this time.
    NOTE:
  1. Position the wheel on the turntable of the tire machine, then lubricate and position the bottom bead of the tire on the wheel.
  2. Position the wheel to align the valve stem with the machine arm, at the 12 o'clock position, and mount the bottom bead of the tire.
    3. Fig 1: Identifying Alignment Position Of Valve Stem With Machine Arm (Bottom Bead Of Tire)
    GF0003002Courtesy of FORD MOTOR CO.
  3. Reposition the wheel to align the valve stem with the machine arm, at the 12 o'clock position, and mount the top bead of the tire.
    4. Fig 2: Identifying Alignment Position Of Valve Stem With Machine Arm (Top Bead)
    GF0003003Courtesy of FORD MOTOR CO.
    NOTE: Use only special tool 204-354 any time tire pressures are measured to be sure that accurate values are obtained.
  4. Inflate the tire to the pressure specified on the vehicle certification label located on the driver door or door pillar.
    5. WARNING: If there is a need to exceed the maximum pressure indicated on the sidewall of the tire, in order to seat the beads, follow ALL the steps listed below. Failure to follow these steps may result in serious personal injury.
  5. The following steps should only be carried out if the tire beads cannot be seated by inflating the tire up to the maximum inflation pressure listed on the tire sidewall. 
    • Relubricate the tire bead and wheel bead seat area.
    • Install a remote valve and pressure gauge.
    • Wear eye and ear protection and stand at a minimum of 3.65 m (12 ft) away from the wheel and tire assembly.
    • Inflate the tire using the remote valve and pressure gauge until the beads have seated or until the pressure gauge is 20 psi more than the maximum inflation pressure indicated on the tire sidewall. If the beads have not seated, deflate the tire and proceed to the next step.
    • Place the wheel and tire assembly in an OSHA approved tire safety cage.
    • Inflate the tire using the remote valve and pressure gauge until the beads have seated or until the pressure gauge is 40 psi more than the maximum inflation pressure indicated on the tire sidewall. Do not exceed 40 psi above the maximum pressure on tire sidewall. Install a new tire if the beads do not seat at this pressure. 
  6. Install the wheel and tire. For additional information, refer to Wheel and Tire  in this article.
scientia non olet · About LEMON Manuals