Transmission Insulator and Retainer: Removal

WARNING: This page is about a different car, the 2007 Lincoln Mark LT and 2007 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.

With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING article.
If equipped, remove the transfer case skid plate.
Remove the 2 bolts for the exhaust hanger.

Fig 1: Locating Bolts For Exhaust Hanger

Courtesy of FORD MOTOR CO.

Remove the rear transmission insulator nuts.

Fig 2: Locating Rear Transmission Insulator Nuts

Courtesy of FORD MOTOR CO.

Install a suitable transmission jack.
Slightly raise the rear of the transmission and remove the bolts. Remove the rear transmission insulator.

Fig 3: Locating Rear Transmission Insulator Bolts

Courtesy of FORD MOTOR CO.