Digital Transmission Range (TR) Sensor: Installation
WARNING: This page is about a different car, the 2007 Lincoln Mark LT and 2007 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
- Install the digital TR sensor and loosely install the bolts.
- Using the special tool, align the digital TR sensor slots. The tool is designed to fit snug.
- Tighten the digital TR sensor bolts.
- Tighten to 9 Nm (80 lb-in).
- Install the manual control lever.
- Position the manual control lever.
- Install a new manual control lever nut.
- Tighten to 33 Nm (24 lb-ft).
- Connect the digital TR sensor electrical connector.
- Connect the selector lever cable end to the manual control lever with the lever in the Overdrive (Circle D) position.
CAUTION:
Tightening one screw before tightening the other may cause the sensor to bind or become damaged.
NOTE:
When installing the selector lever cable, make sure that the selector lever cable locking tabs are locked in place and the selector lever cable end is snapped onto the ball stud. Press the selector lever cable into the selector lever cable bracket and listen for the selector lever cable to click in place. Pull back on the selector lever cable to make sure that it is locked into the selector lever cable bracket. Also make sure that the selector lever cable end is correctly installed onto the ball stud. Pull back on the selector lever cable end to make sure that the selector lever cable end is correctly installed.