LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1806 (Engine - 5.4L (3V) - F-150 & Mark LT) >> Assembly >> Engine >> Late build vehicles

Late build vehicles

WARNING: This page is about a different car, the 2007 Lincoln Mark LT and 2007 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
    CAUTION: When installing the valve cover, make sure to avoid damaging the VCT solenoid.
    Fig 1: Tightening RH Valve Cover In Sequence
    GF0002740Courtesy of FORD MOTOR CO.
  1. Position the RH valve cover and gasket on the cylinder head and tighten the fasteners in the sequence shown.
    • Tighten to 10 Nm (89 lb-in).


    CAUTION: When installing the valve cover, make sure to avoid damaging the VCT solenoid.
    Fig 1: Tightening LH Valve Cover In Sequence
    GF0002744Courtesy of FORD MOTOR CO.
  1. Position the LH valve cover and gasket on the cylinder head and tighten the fasteners in the sequence shown.
    • Tighten to 10 Nm (89 lb-in).
scientia non olet · About LEMON Manuals