Driveline Angle Measurement: Notes
WARNING: This page is about a different car, the 2007 Lincoln Mark LT and 2007 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
Special Tools
| Illustration | Tool Name | Tool Number |
|---|---|---|
| Anglemaster II Driveline Inclinometer/Protractor | 164-R2402 or equivalent |
NOTE:
This procedure does not apply to constant velocity (CV) joints, flex couplers or double cardan joints that are used in some driveshafts. This check is for single-cross and roller-style joints found in the driveshafts.
NOTE:
Prior to checking driveline angularity, inspect the U-joints for correct operation.
NOTE:
An incorrect driveline angle can cause a vibration or shudder. For additional information, refer to NOISE, VIBRATION AND HARSHNESS
article.
NOTE:
Driveline angularity is the angular relationship between the engine crankshaft, the driveshaft and the rear axle pinion. Factors determining driveline angularity include ride height, rear spring and engine mounts.