All bushings

WARNING: This page is about a different car, the 2007 Lincoln Mark LT and 2007 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: It is not necessary to remove the axle assembly from the jack.

Remove the front drive axle assembly. For additional information, refer to Axle Assembly in this article.
Measure and record the width of the gap between the bushing front lip and the housing. Mark the housing at the point where the measurement was taken.

Fig 1: Measuring Width Of Gap Between Busing Front Lip And Housing
Courtesy of FORD MOTOR CO.

Inspect the bushing bores for wear or damage.