LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1797 (Rear Disc Brake System - F150 & Mark LT) >> Removal And Installation >> Rear Disc Brake Shield >> Removal

Rear Disc Brake Shield: Removal

WARNING: This page is about a different car, the 2007 Lincoln Mark LT and 2007 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the rear axle. For additional information, refer to REAR DRIVE AXLE/DIFFERENTIAL - FORD 8.8-INCH RING GEAR article, REAR DRIVE AXLE/DIFFERENTIAL - FORD 9.75-INCH RING GEAR article or REAR DRIVE AXLE/DIFFERENTIAL - FORD 10.25-INCH RING GEAR article.
  2. Remove the parking brake shoes. For additional information, refer to PARKING BRAKE AND ACTUATION article.
  3. Remove the 4 brake caliper support bracket nuts and bolts.
    • To install, tighten to 81 Nm (60 lb-ft).
  4. If equipped, drill out the 2 rivets.
    Fig 1: Locating 2 Rivets
    GF0003388Courtesy of FORD MOTOR CO.
    • Protect the seal and bearings from chips.
    • It is not necessary to install new rivets.
  5. Separate the brake disc shield from the brake caliper support bracket and the rear axle housing.
  6. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals