Rear Brake Pads: Installation
WARNING: This page is about a different car, the 2007 Lincoln Mark LT and 2007 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
- Using a suitable tool and a worn brake pad, compress the caliper piston into the caliper.
- Install the 2 new spring clips and brake pads.
- Position the brake caliper and install the 2 guide pin bolts.
- Tighten to 30 Nm (22 lb-ft).
- Test the brakes for normal operation.
CAUTION:
Protect the piston and boot when pushing the piston into the caliper bore.
CAUTION:
Do not allow grease, oil, brake fluid or other contaminants to contact the pad lining material. Do not install contaminated pads.
NOTE:
Install all new hardware supplied with the pad kit and spring kit.