LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1784 (Engine Controls - Powertrain DTC Charts And Descriptions (Except Diesel & Hybrid)) >> DTC Diagnosis >> P0301 - P0309 - Cylinder X Misfire Detected

P0301 - P0309 - Cylinder X Misfire Detected

WARNING: This page does not describe the selected car, but rather 32 other vehicles, including the 2007 Mercury Mountaineer, 2007 Mercury Monterey, 2007 Mercury Montego, 2007 Mercury Milan, and 2007 Mercury Mariner. However, it is still accessible from the selected car via links, so may be relevant.
P030X - CYLINDER X MISFIRE DETECTED

Description:  NOTE: x represents cylinder numbers 1 through 9.
The misfire detection monitor is designed to monitor engine misfire and identify the specific cylinder in which the misfire has occurred. Misfire is defined as lack of combustion in a cylinder due to absence of spark, poor fuel metering, poor compression, or any other cause.
Possible Causes: 
  • Ignition system
  • Fuel injectors
  • Running out of fuel
  • EVAP canister purge valve
  • Fuel pressure
  • Evaporative emission system
  • EGR system
  • Base engine
Diagnostic Aids:  The malfunction indicator lamp (MIL) blinks once per second when a misfire severe enough to cause catalyst damage is detected. If the MIL is on steady state due to a misfire, this indicates the threshold for emissions was exceeded and caused the vehicle to fail an inspection and maintenance tailpipe test.
Application  Key On Engine Off  Key On Engine Running  Continuous Memory 
All - - refer to PINPOINT TEST HD .
scientia non olet · About LEMON Manuals