P0193 - Fuel Rail Pressure Sensor A Circuit High
WARNING: This page does not describe the selected car, but rather 32 other vehicles, including the 2007 Mercury Mountaineer, 2007 Mercury Monterey, 2007 Mercury Montego, 2007 Mercury Milan, and 2007 Mercury Mariner. However, it is still accessible from the selected car via links, so may be relevant.
P0193 - FUEL RAIL PRESSURE SENSOR A CIRCUIT HIGH
| Description: | The comprehensive component monitor (CCM) monitors the fuel rail pressure (FRP) sensor circuit to the powertrain control module (PCM) for high voltage. The test fails if the voltage exceeds a calibrated limit for a calibrated amount of time during testing. | |||
| Possible Causes: |
|
|||
| Diagnostic Aids: | An FRP signal high condition can be caused by any number of conditions, including a short on FRP signal to VREF, a more positive voltage level, an open FRP signal or signal return. The FRP signal line is pulled up by the PCM and VREF at the sensor, and down by the sensor through SIGRTN. | |||
| Application | Key On Engine Off | Key On Engine Running | Continuous Memory | |
| All | refer to PINPOINT TEST DD . | |||