LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1764 (Engine Emission Control - 3.0L (4V)) >> Removal And Installation >> Exhaust Gas Recirculation (EGR) Valve >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2006 Mercury Milan, 2006 Lincoln Zephyr, and 2006 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the exhaust gas recirculation (EGR) valve electrical connector.
  2. Disconnect the EGR tube fitting from the EGR valve.
    • To install, tighten to 40 Nm (30 lb-ft).
  3. Remove the 2 bolts and the EGR valve.
    • Discard the gasket.
    • To install, tighten to 25 Nm (18 lb-ft).
    4. CAUTION: Do not use metal scrapers, wire brushes, power abrasive discs or other abrasive means to clean the sealing surfaces. These tools cause scratches and gouges that make leak paths. Use a plastic scraping tool to remove all traces of the EGR system module gasket.
    NOTE: If there is no residual gasket material present, metal surface prep can be used to clean and prepare the surfaces.
  4. Clean the mating surfaces of any residual gasket material.
  5. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals