LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1744 (Instrument Panel And Console) >> Removal And Installation >> Instrument Panel Center Finish Panel >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2006 Mercury Milan, 2006 Lincoln Zephyr, and 2006 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.

    Fusion, Milan 

  1. Using a suitable tool, gently pry out the upper center instrument panel finish panel to disengage the clips.
  2. Remove the upper center instrument panel finish panel.
    • Disconnect the electrical connectors.
  3. Using a suitable tool, gently pry out the lower center instrument panel finish panel to disengage the clips.
  4. Remove the lower center instrument panel finish panel.
    • Disconnect the electrical connectors.
  5. Zephyr 

  6. Remove the floor console trim panel.
  7. Remove the lower center instrument panel finish panel screw beneath the ash receptacle and the lower center instrument panel finish panel.
    • Disconnect the electrical connectors.
  8. Remove the 2 upper center instrument panel finish panel lower screws.
    Fig 1: Locating Upper Center Instrument Panel Finish Panel Lower Screws
    G04683676Courtesy of FORD MOTOR CO.
  9. CAUTION: To avoid damage to the center instrument panel registers, rotate either left or right and pull straight out. Do not wiggle the register from side to side to free it.
    NOTE: LH center instrument panel register shown, RH similar.
    Fig 2: Locating Center Instrument Panel Registers
    G04683677Courtesy of FORD MOTOR CO.
  10. Remove both center instrument panel registers.
  11. Working through the center instrument panel register openings, remove the 2 upper center instrument panel finish panel upper screws.
  12. Remove the upper center instrument panel finish panel.
    • Disconnect the electrical connectors.
  13. All vehicles 

  14. To install, reverse removal procedure.