LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1741 (Parking Brake & Actuation) >> Removal And Installation >> Parking Brake Control >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2006 Mercury Milan, 2006 Lincoln Zephyr, and 2006 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the floor console. For additional information, refer to INSTRUMENT PANEL AND CONSOLE .
  2. Make sure the parking brake control is in the released position.
  3. Disconnect the warning indicator switch electrical connector.
  4. Loosen the parking brake control adjusting nut.
  5. Remove the 2 parking brake control nuts.
    • To install, tighten to 20 Nm (15 lb-ft).
  6. Remove the parking brake control bolt and the parking brake control.
    • To install, tighten to 20 Nm (15 lb-ft).
  7. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals