LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1735 (Manual Transaxle/Transmission) >> In-Vehicle Repair >> Halfshaft Seal >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2006 Mercury Milan and 2006 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: New halfshaft oil seals should be installed anytime the halfshafts are removed. Failure to install new halfshafts seals may result in transaxle oil leak(s).
  1. Remove the transaxle drain plug and drain the fluid.
  2. Remove the RH intermediate shaft or LH halfshaft. For additional information, refer to FRONT DRIVE HALFSHAFTS .
  3. Using the special tools, remove the RH intermediate shaft oil seal or the LH halfshaft oil seal.
    Fig 1: Identifying Special Tools
    G04682103Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals