Coolant Pump Belt: Installation
WARNING: This page is about a different car, the 2006 Mercury Milan, 2006 Lincoln Zephyr, and 2006 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the 4 screws and position the RH fender splash shield aside.
- Remove the 6 pin-type retainers (4 shown) and the RH splash shield.
- Install the coolant pump belt on the coolant pump pulley and position it on the camshaft pulley.
- Rotate the crankshaft clockwise to seat the coolant pump belt on the camshaft pulley.
- If equipped, install the coolant pump belt shield and the nuts.
- Tighten to 6 Nm (53 lb-in).
- Install the RH splash shield and the 6 pin-type retainers (4 shown).
- Position the RH fender splash shield and install the 4 screws.
NOTE:
To install the coolant pump belt, remove the 2 splash shields for access to the crankshaft bolt.
CAUTION:
Do not use any screwdrivers, pliers or other metal objects that could cause damage to the belt or camshaft pulley while installing the belt.