Transaxle Support Insulator: Removal

WARNING: This page is about a different car, the 2006 Mercury Milan, 2006 Lincoln Zephyr, and 2006 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.

With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
Remove the battery and battery tray. For additional information, refer to BATTERY, MOUNTING AND CABLES .
Install the universal lifting brackets on the LH side of the engine.

Fig 1: Identifying Special Tools
Courtesy of FORD MOTOR CO.
Using the special tools, support the engine.

Fig 2: Identifying Special Tools For Supporting Engine
Courtesy of FORD MOTOR CO.
Remove the 2 bolts from the transaxle insulator.

Fig 3: Locating Bolts On Transaxle Insulator
Courtesy of FORD MOTOR CO.
Remove the 2 upper bolts for the rear transaxle insulator.

Fig 4: Locating Bolts On Rear Transaxle Insulator
Courtesy of FORD MOTOR CO.
Remove the 4 screws and position the LH fender splash shield aside.

Fig 5: Locating Screws On LH Fender Splash Shield
Courtesy of FORD MOTOR CO.
Remove the 6 pin-type retainers and the LH front structure-to-subframe splash shield.

Fig 6: Locating LH Front Structure-To-Subframe Splash Shield
Courtesy of FORD MOTOR CO.
Remove the 2 lower bolts for the rear transaxle insulator and remove the insulator.

Fig 7: Locating Bolts On Rear Transaxle Insulator
Courtesy of FORD MOTOR CO.