LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1724 (Automatic Transmission - 6 Speed) >> In-Vehicle Repair >> Differential Seals - LH >> Removal

Differential Seals - LH: Removal

WARNING: This page is about a different car, the 2006 Mercury Milan, 2006 Lincoln Zephyr, and 2006 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: MERCON®, MERCON®V, MERCON®SP, Motorcraft Premium Automatic Transmission Fluid and Motorcraft Continuously Variable Chain Type Transmission Fluid are not interchangeable transmission fluids. The use of any fluid other than what is recommended for this transmission will cause transmission damage.
  1. Remove the LH halfshaft. For additional information, refer to FRONT DRIVE HALFSHAFTS .
    2. CAUTION: Be careful not to damage the case while removing the seal.
    Fig 1: Poking Small Hole In Seal
    G04681492Courtesy of FORD MOTOR CO.
  2. Using a suitable awl, poke a small hole in the seal.
  3. Using a suitable dent puller, remove the LH differential fluid seal.
    Fig 2: Locating Dent Puller
    G04681493Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals