LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1681 (Interior Trim And Ornamentation) >> Removal And Installation >> Parcel Shelf >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2006 Mercury Montego, 2006 Ford Freestyle, and 2006 Ford Five Hundred. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the rear seat cushion. For additional information, refer to REMOVAL AND INSTALLATION .
  2. Remove the rear seat bolsters. For additional information, refer to REMOVAL AND INSTALLATION .
  3. Remove the C-pillar trim panel. For additional information, refer to C-PILLAR TRIM PANEL - FIVE HUNDRED, MONTEGO .
  4. Remove the center seat belt bezel.
  5. Remove the rear center safety belt anchor nut.
    • To install, tighten to 40 N.m (30 lb-ft).
  6. Disconnect the high-mounted stop lamp electrical connector.
  7. Remove the 3 parcel tray pin-type retainers.
  8. Pull the parcel tray toward the front of the vehicle to remove.
  9. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals