LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1681 (Interior Trim And Ornamentation) >> Removal And Installation >> D-Pillar Trim Panel - Freestyle >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2006 Mercury Montego, 2006 Ford Freestyle, and 2006 Ford Five Hundred. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the 3rd row safety belt anchor-to-floor bolt cover from the rear quarter trim panel.
  2. Remove the 3rd row safety belt anchor-to-floor bolt.
    • To install, tighten to 40 N.m (30 lb-ft).
  3. Remove the D-pillar trim panel.
    • Remove the D-pillar trim panel screw cover and screw.
    • Pull the D-pillar trim panel toward the inside of the vehicle to release the retaining tabs.
  4. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals