LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1680 (Seat System) >> Removal And Installation >> Seat Backrest Cover - Front >> Installation

Seat Backrest Cover - Front: Installation

WARNING: This page is about a different car, the 2006 Mercury Montego, 2006 Ford Freestyle, and 2006 Ford Five Hundred. However, it is still accessible from the selected car via links, so may be relevant.

    All seats 

  1. Position the backrest trim cover to the backrest foam pad and backrest frame.
  2. Position the backrest trim cover and install the hog rings.
    1. Position the backrest trim cover on tube above the lumbar support wire hooks.
    2. Install the hog rings.
    Fig 1: Identifying Backrest Trim Cover To Backrest Foam Pad
    G04658724Courtesy of FORD MOTOR CO.
  3. Install the third row of hog rings in front and attach the hook and loop strips.

    4. Seats with side air bag modules 

  4. Roll down the backrest trim cover to the side air bag module.
    5. WARNING:
    1. Check the side air bag deployment chute for damage. The deployment chute must not be repaired. If there is any damage to the deployment chute, the seat back trim cover and deployment chute must be installed new as a unit.
    2. Inspect the side air bag deployment chute and the side air bag cavity in the seat back pad for any foreign objects. If any foreign objects are found remove them. Failure to do so may result in personal injury, in the event of an air bag deployment.
    Fig 2: Locating Side Air Bag Module Backrest Trim Cover Chute & J-Clip
    G04658725Courtesy of FORD MOTOR CO.
  5. Feed the side air bag module backrest trim cover chute and J-clip retainers back through the side air bag module backrest foam pad opening.
  6. Install the side air bag module backrest trim cover chute and J-clips around the side air bag module and backrest frame. Attach the chute J-clips.
    Fig 3: Identifying Air Bag Module Backrest Trim Cover
    G04658726Courtesy of FORD MOTOR CO.

    7. All seats 

  7. Attach the J-clips at the back of the backrest trim cover.
    Fig 4: Locating J-Clips Back Of Backrest Trim Cover
    G04658727Courtesy of FORD MOTOR CO.
  8. Attach the hook and loop strips, roll the backrest trim cover down and install the second row of hog rings in the front.
  9. Attach the hook and loop strips, roll the backrest trim cover down and install the first row of hog rings in the front.

    10. Passenger seat 

  10. Pull the backrest latch fold-flat release strap through the backrest trim cover bezel opening.

    11. All seats 

  11. Attach the backrest trim cover lower J-clip.

    12. Seats with manual lumbar 

  12. Position the lumbar adjust handle clip onto the lumbar adjust handle and push the handle on the lumbar adjuster.

    13. All seats 

    NOTE: The head restraint guides are not interchangeable.
  13. Install the head restraint guides.
  14. Install the head restraint.

    15. Seats with side air bag modules 

  15. Repower the SRS. For additional information, refer to REPOWERING PROCEDURE .
scientia non olet · About LEMON Manuals