LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1680 (Seat System) >> Removal And Installation >> Seat - Rear, Second Row, Freestyle >> Installation

Seat - Rear, Second Row, Freestyle: Installation

WARNING: This page is about a different car, the 2006 Mercury Montego, 2006 Ford Freestyle, and 2006 Ford Five Hundred. However, it is still accessible from the selected car via links, so may be relevant.

    Outboard seat strikers 

  1. Position the outboard seat striker to the floor and install the 2 bolts.
    • Tighten to 48 N.m (35 lb-ft).

    2. Inboard seat strikers 

  2. Position the inboard seat striker to the floor and install the 2 bolts.
    • Tighten to 80 N.m (59 lb-ft).
  3. Position the console bracket cover and install the 2 screws.

    4. RH 40 percent seat 

  4. Position the seat in the vehicle and install the retainers in the following sequence.
    1. Install the riser/seat track-to-floor pan rear inboard nut.
      • Tighten to 48 N.m (35 lb-ft).
    2. Install the riser/seat track-to-floor pan rear outboard nut.
      • Tighten to 48 N.m (35 lb-ft).
    3. Install the riser/seat track-to-floor pan front outboard bolt.
      • Tighten to 48 N.m (35 lb-ft).
    4. Install the riser/seat track-to-floor pan front inboard bolt.
    • Tighten to 48 N.m (35 lb-ft).
    Fig 1: Identifying Riser/Seat Track-To-Floor Pan Front Inboard Bolt
    G04658754Courtesy of FORD MOTOR CO.

    5. LH 40 percent and 60 percent seats 

  5. Position the seat in the vehicle and install the retainers in the following sequence.
    1. Install the riser/seat track-to-floor pan rear inboard nut.
      • Tighten to 48 N.m (35 lb-ft).
    2. Install the riser/seat track-to-floor pan rear outboard nut.
      • Tighten to 48 N.m (35 lb-ft).
    3. Install the riser/seat track-to-floor pan front outboard bolt.
      • Tighten to 48 N.m (35 lb-ft).
    4. Install the riser/seat track-to-floor pan front inboard bolt.
    • Tighten to 48 N.m (35 lb-ft).
    Fig 2: Identifying Riser/Seat Track-To-Floor Pan Front Inboard Bolt
    G04658755Courtesy of FORD MOTOR CO.

    6. All seats 

  6. Make sure the safety belt buckles are accessible to the occupants after installation.
scientia non olet · About LEMON Manuals