LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1640 (HVAC Control System) >> Removal And Installation >> Air Inlet Duct >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2006 Mercury Montego, 2006 Ford Freestyle, and 2006 Ford Five Hundred. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the heater core and evaporator core housing. For additional information, refer to HEATER CORE AND EVAPORATOR CORE HOUSING .
  2. Disconnect the air inlet door mode door actuator electrical connector and detach the wire harness from the air inlet duct.
  3. Remove the 2 front air inlet duct screws.
  4. Remove the remaining 5 air inlet duct screws.
  5. Remove the air inlet duct.
  6. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals