LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1636 (Engine Cooling) >> Removal And Installation >> Cooling Fan Motor and Shroud >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2006 Mercury Montego, 2006 Ford Freestyle, and 2006 Ford Five Hundred. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the battery ground cable. For additional information, refer to BATTERY DISCONNECT .
  2. Disconnect the 2 coolant hose retainers from the fan shroud and position aside.
  3. Disconnect the cooling fan motor electrical connector.
  4. Remove the 2 cooling fan motor and shroud bolts and release the cooling fan motor and shroud from the lower brackets.
    • To install, tighten to 6 N.m (53 lb-in).
  5. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals