Removal and Installation

WARNING: This page is about a different car, the 2006 Ford Pickup, 2006 Ford F550 Super Duty, 2006 Ford F450 Super Duty, and 2006 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

Remove the scuff plate.
Remove the cowl side trim panel. For additional information, refer to INTERIOR TRIM AND ORNAMENTATION .
Pull the carpet or mat back to see the front body insulator plug button.

Fig 1: Locating Front Body Insulator Plug Button
Courtesy of FORD MOTOR CO.
Remove the button.

Fig 2: Locating Button
Courtesy of FORD MOTOR CO.
Remove and discard the bolt.
- To install, tighten to 80 Nm (60 lb-ft).
  
  Fig 3: Locating Bolt
  Courtesy of FORD MOTOR CO.
Remove the insulator.

Fig 4: Locating Insulator
Courtesy of FORD MOTOR CO.

NOTE: Do not reuse body support mounting fasteners. New fasteners must be installed for each fastener that has been removed or loosened.

NOTE: No lubricants of any kind are to be used during body insulator installation.

To install, reverse the removal procedure.