LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1605 (HVAC Control System-General Information And Diagnostics - F250-F550 Super Duty) >> General Procedures >> Heater Hose Coupling >> Connect

Heater Hose Coupling: Connect

WARNING: This page is about a different car, the 2006 Ford Pickup, 2006 Ford F550 Super Duty, 2006 Ford F450 Super Duty, and 2006 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Clean the tubes and lubricate with MERPOL® meeting Ford specification ESE-M99B144-B or plain water.
  2. Install a new coupling retainer, spacer, and lubricated O-ring seals into the quick disconnect coupling housing.
    Fig 1: Locating Coupling Retainer, Spacer, And Lubricated O-Ring Seals
    G04645033Courtesy of FORD MOTOR CO.
  3. Push the heater water hose with a quick disconnect coupling onto the tube.
    Fig 2: Locating Heater Water Hose With Quick Disconnect Coupling Onto Tube
    G04645034Courtesy of FORD MOTOR CO.
  4. Make sure the coupling is fully engaged by lightly pulling on the heater water hose.
scientia non olet · About LEMON Manuals