LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1604 (Body Panel System - Front End Body Panels -- F250-F550 Super Duty) >> Removal And Installation >> Fender Splash Shield >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2006 Ford Pickup, 2006 Ford F550 Super Duty, 2006 Ford F450 Super Duty, and 2006 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the electrical connectors (left side only).
    Fig 1: Locating Electrical Connectors (Left Side Only)
    G04645730Courtesy of FORD MOTOR CO.
  2. Remove the wheel and tire assembly. For additional information, refer to WHEELS & TIRES .
  3. If equipped with running boards, loosen the 16 running board bolts.
    Fig 2: Locating Running Board Bolts
    G04645731Courtesy of FORD MOTOR CO.
  4. Remove the front fender splash shield pin-type retainers.
    Fig 3: Locating Front Fender Splash Shield Pin-Type Retainers
    G04645732Courtesy of FORD MOTOR CO.
  5. Remove the front fender splash shield.
    1. Remove the screws.
    2. Remove the nuts (right side only).
    3. Remove the bolts.
      Fig 4: Locating Front Fender Splash Shield
      G04645733Courtesy of FORD MOTOR CO.
  6. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals