LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 16 (Engine - 4.2L V6 - VIN 2) >> Removal & Installation >> Front Cover Oil Seal >> Removal

Front Cover Oil Seal: Removal

WARNING: This page is about a different car, the 2001 Ford Pickup, 2001 Ford Econoline, 2000 Ford Pickup, and 2000 Ford Econoline. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect negative battery cable. Remove accessory drive belt. Remove cooling fan and fan shroud. Raise and support vehicle. Mark pulley and damper position. Remove crankshaft pulley. Remove damper bolt.
  2. Install Crankshaft Damper Remover (T58P-6316-D) and Crankshaft Damper Remover Adapter (T82L-6316-B). Remove damper. Using Seal Remover (T92C-6700-CH), remove oil seal from front cover.
scientia non olet · About LEMON Manuals