LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1585 (Anti-Lock Brake System -- F250-F550 Super Duty) >> Removal And Installation >> Wheel Speed Sensor - Rear >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2006 Ford Pickup, 2006 Ford F550 Super Duty, 2006 Ford F450 Super Duty, and 2006 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Clean off dirt and foreign material that may have collected around the rear axle speed sensor before removal to prevent fluid contamination.
  1. Disconnect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES .
  2. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
  3. Disconnect the rear axle speed sensor electrical connector.
    NOTE: Do not apply force to the plastic rear axle speed sensor connector.
  4. Remove the bolt and the rear axle speed sensor. To install, tighten to 20 Nm (15 lb-ft).
  5. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals