LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1578 (Fuel System & Engine Controls - 5.4L (3V) - F250 & F350 Super Duty) >> Removal And Installation >> Throttle Body >> Installation

Throttle Body: Installation

WARNING: This page is about a different car, the 2006 Ford Pickup, 2006 Ford Cutaway, and 2006 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Using a new O-ring seal, install the TB and tighten the 4 bolts in 2 stages.
    • Stage 1: Tighten to 9 Nm (80 lb-in).
    • Stage 2: Tighten an additional 90 degrees (1/4 turn).
  2. Connect the TP sensor electrical connector.
  3. Connect the electronic throttle control electrical connector.
  4. Install the air cleaner assembly. For additional information, refer to INTAKE AIR DISTRIBUTION & FILTERING .
  5. Connect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES .
scientia non olet · About LEMON Manuals