LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1577 (Brake System - General Information -- F250-F550 Super Duty) >> General Procedures >> Brake System Leak Check

Brake System Leak Check

WARNING: This page is about a different car, the 2006 Ford Pickup, 2006 Ford F550 Super Duty, 2006 Ford F450 Super Duty, and 2006 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: Brake fluid is water soluble and it is possible that all evidence of fluid leakage has been washed off if the vehicle has been operated in the rain or snow.
  1. Make sure the brake master cylinder reservoir is full.
  2. Apply the brakes several times and make sure the pedal feel is not spongy. If necessary, bleed the system. For additional information, refer to BRAKE SYSTEM BLEEDING  in this section.
  3. Verify that the reservoir level is not dropping.
  4. If the reservoir level is dropping, inspect the brake components, fittings and lines to locate the source of the leak.
scientia non olet · About LEMON Manuals