LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1565 (Acceleration Control System - F250-F550 Super Duty 6.0L (99P F450/550)) >> Removal And Installation >> Accelerator Pedal - Fixed >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2006 Ford Pickup, 2006 Ford F550 Super Duty, 2006 Ford F450 Super Duty, and 2006 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES .
  2. Disconnect the accelerator pedal and position sensor assembly electrical connector.
  3. Remove the 3 bolts and the accelerator pedal and position sensor assembly.
    • To install, tighten to 25 Nm (18 lb-ft).
  4. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals