LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1564 (Automatic Transmission - F250-F550 Super Duty) >> In-Vehicle Repair >> Internal Harness Service >> Removal

Internal Harness Service: Removal

WARNING: This page is about a different car, the 2006 Ford Pickup, 2006 Ford F550 Super Duty, 2006 Ford F450 Super Duty, and 2006 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the solenoid body assembly. For additional information, refer to SOLENOID BODY ASSEMBLY .
  2. Disconnect the internal wiring harness.
    1. Remove the 2 screws.
    2. Disconnect the transmission fluid temperature sensor electrical connector.
    3. Disconnect the solenoid electrical connectors.
      Fig 1: Identifying Solenoid Electrical Connectors
      G04649668Courtesy of FORD MOTOR CO.
  3. Remove the bulkhead connector O-ring seal.
    Fig 2: Identifying Bulkhead Connector O-Ring
    G03889120Courtesy of FORD MOTOR CO.
  4. Lift the tab twisting the bulkhead connector, push it through the solenoid body and remove the wire harness.
scientia non olet · About LEMON Manuals